Fita de LED linear de silicone flexível e macia de alta tensão 220V, RGB, para ambientes externos, à prova d'água.

For outdoor use or in humid environments, connectors and tails need to be sealed with glue to protect against water ingress and prolonged exposure to water. Regular options are not recommended for use in wet environments. Regular options are recommended for use not exceeding four hours a day and long-lasting options are recommended for no more than ten hours a dayDo not use for long periods of time, do not operate while powered on, use with suspension at about half a meter distance, do not forcefully pull the light strip, do not damage the light strip, install the light strip on insulating material, do not use conductive material to fix the light strip as it can easily cause short circuit, do not let the light strip bear force and deform, do not install in conductive or flammable/explosive environments, do not install in sealed environments, need to be installed in a well-ventilated and heat-dissipating environment, the light strip can only be connected to a single-head plug, 220v light strips have flicker when shooting, if you need a flicker-free plug, you can contact customer service for customization, the light strip cannot be installed in aluminum channels for use, aluminum channels cannot dissipate heat, there is no warranty for use in aluminum channels (except aluminum channel models), adhesive-backed models require distance separation and glue reinforcement for installation, the light strip can only be cut at a whole meter blank space, the whole roll of light strip cannot light up, it needs to be spread out for testing, it can be rolled upThe starting point light cannot dissipate heat easily causing the middle to melt. The pins should be inserted into the core of the wire and not off-center (off-center insertion can easily cause tripping and damage to the plug and light strip). The light strip has positive and negative poles that do not light up when installed correctly. If the plug is not inserted correctly, the light strip can be turned around to light up. The light strip needs to be connected with a matching plug to be used. Failure to match or not connecting the plug can easily cause damage. Buyers are advised to read this detail page before purchasing and install according to the recommendations in the detail page. Failure to install according to the recommendations in the detail page will result in losses borne by the buyer. The seller does not provide warranty. The light strip requires a matching plug after using for a while. Single-color light strips require single-color plugs, and four-color light strips require four-color plugs. It can flash quickly and slowly as a whole. Six-color light strips require six-color plugs to jump and run around. Seven-color light strips require seven-color plugs to change color as a whole. With a remote control seven-color plug, it can be controlled remotelyControl single-color changing mode to adjust brightness and speed etc., the three-color light strip has dual-color light beads on it, another color has dual-color simultaneous lighting effect. To use one section, you need to connect a three-color plug and a regular household switch (switch not sold). After connecting, switch to change one color to stay on continuously. Multiple sections in one area cannot synchronize dimming.